Page 1 of 1
low speed needle
Posted: Fri Nov 27, 2020 10:15 pm
by lynn haddock
Need a low speed adjusting screw for a Mac 9 flat back carb --- anyone ? thanks
Re: low speed needle
Posted: Mon Nov 30, 2020 5:30 pm
by REAR
Lynn,
Might have what your looking for. Give me till tomorrow to post up some pictures.
Bob Kurkowski
Re: low speed needle
Posted: Tue Dec 01, 2020 9:29 am
by REAR
Lynn,
I know nothing about Mc carbs and I plan on keeping it that way but I think these needles may be Mc.
See if there is anything you can use then send me your address thru this site.
Bob K.
Re: low speed needle
Posted: Sun Dec 13, 2020 7:00 pm
by lynn haddock
found one but THANKS for the reply ............> LH