Page 1 of 1
Wanted Early Rupp steering shaft
Posted: Wed Feb 15, 2012 11:33 am
by Chris Marchand
Need a steering shaft for a 60/61 Super K. Its the one that the 1/2 round Aluminum steeering wheel fits on . Tapered where the steering wheel fits and a 90 degree bend at the fulcrum point end where the tie rods connect. Thx Chris
Re: Wanted Early Rupp steering shaft
Posted: Wed Feb 15, 2012 1:44 pm
by Rob Voska
If you can't find one I can fab one. I have a Super K to copy from.
Re: Wanted Early Rupp steering shaft
Posted: Wed Feb 15, 2012 8:37 pm
by Tom Smith
I have one I don't use but it is threaded not tapered. I suppose you could taper it.
Re: Wanted Early Rupp steering shaft
Posted: Wed Feb 15, 2012 9:07 pm
by Chris Marchand
Tom , Its interesting that some were straight and threaded vs. tapered and threaded . This steering wheel is messed up at the taper and it needs Tig d and restored so I am going to get that taken care of first. It may end up a non tapered steering wheel , if so I will gladly take that shaft off your hands. Will know in a couple weeks. Thx Chris
Re: Wanted Early Rupp steering shaft
Posted: Thu Feb 16, 2012 5:21 pm
by Chris Marchand
Rob agreed to look at the wheel and figure out if its fixable and if so machine a shaft that will work. Thx Rob
