Wanted Early Rupp steering shaft

Chris Marchand · Post by **Chris Marchand** » Wed Feb 15, 2012 11:33 am

Need a steering shaft for a 60/61 Super K. Its the one that the 1/2 round Aluminum steeering wheel fits on . Tapered where the steering wheel fits and a 90 degree bend at the fulcrum point end where the tie rods connect. Thx Chris

Rob Voska · Post by **Rob Voska** » Wed Feb 15, 2012 1:44 pm

If you can't find one I can fab one. I have a Super K to copy from.

Tom Smith · Post by **Tom Smith** » Wed Feb 15, 2012 8:37 pm

I have one I don't use but it is threaded not tapered. I suppose you could taper it.

Chris Marchand · Post by **Chris Marchand** » Wed Feb 15, 2012 9:07 pm

Tom , Its interesting that some were straight and threaded vs. tapered and threaded . This steering wheel is messed up at the taper and it needs Tig d and restored so I am going to get that taken care of first. It may end up a non tapered steering wheel , if so I will gladly take that shaft off your hands. Will know in a couple weeks. Thx Chris

Chris Marchand · Post by **Chris Marchand** » Thu Feb 16, 2012 5:21 pm

Rob agreed to look at the wheel and figure out if its fixable and if so machine a shaft that will work. Thx Rob

Wanted Early Rupp steering shaft

Wanted Early Rupp steering shaft

Re: Wanted Early Rupp steering shaft

Re: Wanted Early Rupp steering shaft

Re: Wanted Early Rupp steering shaft

Re: Wanted Early Rupp steering shaft