rearenginekarts.com

Hi,
I just finished the re-biuld of my first Mc101A.
This is my first 101, I have built several mac's both standard and super and after finishing it and bolting on a GEM starter cup, I realized that it does not stick out far enough from the flywheel cover to get the starter belt on.

So here is my question:
Are there special extended cups for 101 only? If so, where can I get one.

A rewind starter might be an option but it looks like a standard one may not fit although I have not tried as yet. I have a couple std mac rewinds and could use them if the fit.

Any advice would be greatly appreciated.
I'm a 101 novice!!

Scott

101's use a longer starter cup. The starter is also longer on a pull starter.

All the Mac reed engines used the same basic recoil starter with the engagement dog being different on the 101's so swapping them around is easy if you can locate both lengths of engagement dogs.

Mc Bob.

... skip the recoil starter idea, it's brutal trying to start a 101 with a recoil, if it doesn't kick back and almost rip your arm off, you will be too tired to drive the kart after finally getting it started! There are long MC101 starter pullies floating around the small diameter billet ones seem most available, but you need a good torque electric starter to spin (a weak starter motor or battery might not spin it well). I use a gear reduction starter motor with full size car battery, and the small diameter long billet pullies on my 101's .... here watch the beginning of this clip, where I am getting a start on my dual MC101 Chaparral at TBO last year!

http://www.youtube.com/watch?v=zXldiL7wcQI

I attached 2 photos, one is the big diameter GEM type cast MC101 starter cup, and the other is the billet small diameter MC101 starter cup (I believe APPCO used to make many of these billet cups in the mid 70's)

FYI - the fan shroud is wider on the 101's, that is why you need the longer pulley or recoil. If need be, a standard super engine shroud (pre MC101) can be put on, and then you don't need the longer pulley or recoil (could get you by temporarily, I've done it).

and remember, all the videos from TBO last year are on this page...
http://rearenginekarts.com/video%20-%20 ... 202007.htm

Jeff