Looking to I D some engine parts

Post all your vintage karting messages here in the General Discussion Forum

Moderator: Rob Voska

Post Reply
Mark Loraine
Posts: 62
Joined: Fri May 08, 2009 10:51 pm
Vintage Karting items owned: ProX 77,McC R1,Bug Stinger Dual.
User Agreement: Yes
Location: SWNY14755

Looking to I D some engine parts

Post by Mark Loraine » Wed Sep 16, 2020 8:45 pm

Looking to I D, 2 head and an intake adapter plate, any one know what these are?
Thanks,
Mark L./SWNY
Attachments
HPIM2158.JPG

Mark Loraine
Posts: 62
Joined: Fri May 08, 2009 10:51 pm
Vintage Karting items owned: ProX 77,McC R1,Bug Stinger Dual.
User Agreement: Yes
Location: SWNY14755

Re: Looking to I D some engine parts

Post by Mark Loraine » Wed Sep 16, 2020 8:47 pm

Need to I D these parts, anyone up for positive identification.
Attachments
HPIM2159.JPG

Rob Voska
Posts: 1479
Joined: Fri Jun 15, 2007 9:04 am

Re: Looking to I D some engine parts

Post by Rob Voska » Wed Sep 16, 2020 8:55 pm

Reed engineering head is for a Power Products.

Other head hard to tell. Modified to fit on a McCulloch or is it a 100CC BM head?

Mark Loraine
Posts: 62
Joined: Fri May 08, 2009 10:51 pm
Vintage Karting items owned: ProX 77,McC R1,Bug Stinger Dual.
User Agreement: Yes
Location: SWNY14755

Re: Looking to I D some engine parts

Post by Mark Loraine » Fri Sep 18, 2020 2:42 pm

Thank you for your response;

The BM heads use an 8mm stud to mount head, these holes are either ¼” or for 6mm.(.260”)
Also the overall width of this head is 4 & 7/8” diameter, smaller than the BM heads.
The spark plug hole looks like it’s for long reach B9ES or N-2.
Top of the plughole to the deck is 1.300”.
CTC mount holes are 1.313” approx.
Holes do not line up with McCulloch.
Weighs 1-pound 1.55ozs
99 % sure this is kart related due to the location it came from.

Mark

Post Reply