Pro/Engineer CAD

Post all your vintage karting messages here in the General Discussion Forum

Moderator: Rob Voska

Post Reply
ted johnson
Posts: 1685
Joined: Fri Jun 15, 2007 7:59 am

Pro/Engineer CAD

Post by ted johnson » Wed Aug 05, 2020 4:27 pm

Do we have a Pro/Engineer Wildfire operator among our Vintage Kart ranks? I run Wildfire 4.0, and I just finished a quite busy drawing of a complex part. I need to copy the part file under a new name, and I need to copy the drawing and rename it also. It must still remain associative. I'm aware it can be done, but I'm a Designer, not an administrator. I've used Pro/E only in aerospace, where the parts are one-off prototypes. Any ideas? Thanks. Ted

Post Reply