rearenginekarts.com

The Power Products PP58 AND 81, 82
Question

Did anyone make a dual carb manifold for the PP81,82 engine I thought I seen one on ebay sometime back I wonder if anymore are around.

I have one dual carb manifold for a PP58 here I got off of ebay.

McBob

Bob,

Steen's offered a adaptor plate #P27F that allowed the #P27D Dual intake manifold for a AH -58 to be used on the AH 82 engine. Not sure who the actual mfg. is on the components, could be Palmini.

There were a lot of folks popping out hot rod parts in the early days so there should be something floating around out there.

R.E.A.R.

REAR wrote:Bob,

Steen's offered a adaptor plate #P27F that allowed the #P27D Dual intake manifold for a AH -58 to be used on the AH 82 engine. Not sure who the actual mfg. is on the components, could be Palmini.

There were a lot of folks popping out hot rod parts in the early days so there should be something floating around out there.

R.E.A.R.

Thanks REAR

REED ENG was very common on the AH-47 58 61 81 82 motors. The 81/82 used an adapter plate REED 436. REED 434 was the dual carb manifold for Homelite or GO Power reed assemblies. This manifold was used on many different brand motors with correct adapter plates.

Thanks Fellas