The Power Products PP58 AND 81, 82

Post all your vintage karting messages here in the General Discussion Forum

Moderator: Rob Voska

Post Reply
Bob Cornwell
Posts: 18
Joined: Fri Jul 25, 2008 8:02 pm
Vintage Karting items owned: Hmm only hotsaws so far

The Power Products PP58 AND 81, 82

Post by Bob Cornwell » Thu Mar 02, 2017 7:15 pm

The Power Products PP58 AND 81, 82
Question

Did anyone make a dual carb manifold for the PP81,82 engine I thought I seen one on ebay sometime back I wonder if anymore are around.

I have one dual carb manifold for a PP58 here I got off of ebay.

McBob

REAR
Posts: 1221
Joined: Sat Jun 16, 2007 10:19 am

Re: The Power Products PP58 AND 81, 82

Post by REAR » Fri Mar 03, 2017 7:56 am

Bob,

Steen's offered a adaptor plate #P27F that allowed the #P27D Dual intake manifold for a AH -58 to be used on the AH 82 engine. Not sure who the actual mfg. is on the components, could be Palmini.

There were a lot of folks popping out hot rod parts in the early days so there should be something floating around out there.

R.E.A.R.

Bob Cornwell
Posts: 18
Joined: Fri Jul 25, 2008 8:02 pm
Vintage Karting items owned: Hmm only hotsaws so far

Re: The Power Products PP58 AND 81, 82

Post by Bob Cornwell » Wed Mar 08, 2017 10:54 pm

REAR wrote:Bob,

Steen's offered a adaptor plate #P27F that allowed the #P27D Dual intake manifold for a AH -58 to be used on the AH 82 engine. Not sure who the actual mfg. is on the components, could be Palmini.

There were a lot of folks popping out hot rod parts in the early days so there should be something floating around out there.

R.E.A.R.
Thanks REAR

Terry Bentley
Posts: 126
Joined: Wed Nov 10, 2010 3:21 am
Vintage Karting items owned: Kavalla Rupp Hornet Bug Margay Cates, Ala Kart
User Agreement: Yes
Location: East of DFW

Re: The Power Products PP58 AND 81, 82

Post by Terry Bentley » Sat Mar 18, 2017 11:49 pm

REED ENG was very common on the AH-47 58 61 81 82 motors. The 81/82 used an adapter plate REED 436. REED 434 was the dual carb manifold for Homelite or GO Power reed assemblies. This manifold was used on many different brand motors with correct adapter plates.

Bob Cornwell
Posts: 18
Joined: Fri Jul 25, 2008 8:02 pm
Vintage Karting items owned: Hmm only hotsaws so far

Re: The Power Products PP58 AND 81, 82

Post by Bob Cornwell » Sun Mar 19, 2017 1:08 am

Thanks Fellas

Post Reply