Are these MC-1 parts?
Posted: Thu Nov 17, 2011 10:22 pm
Anybody familiar with MC-1 parts?
This crank has a pin with a .750 diameter and this rod has a .750 ID on the big end.
The rod is aluminum, 2.500 from center to center, just like early Mac rods.
The rod does not appear to take a bearing on the big end.
I'm asking because they came in the box with an MC-1 block and an MC-2 block
This crank has a pin with a .750 diameter and this rod has a .750 ID on the big end.
The rod is aluminum, 2.500 from center to center, just like early Mac rods.
The rod does not appear to take a bearing on the big end.
I'm asking because they came in the box with an MC-1 block and an MC-2 block