Page 1 of 1
carb question
Posted: Fri Dec 07, 2007 7:32 am
by Brian Thomas
I want to do a 3 carb motor, what small bore hl series tillies would you use for alky ?
Any input would be great.
Thanks
Brian
Re: carb question
Posted: Fri Dec 07, 2007 8:41 am
by Rob Voska
Carb work by the air going thru the bore of the carb. You will still need 3 alky carbs. I would look for small bore 250's or something. You could also drill your small bore gas carbs but you will need to make sure you have alky needles etc.....
Re: carb question
Posted: Fri Dec 07, 2007 10:05 am
by Brian Thomas
I was wondering about smaller bore carbs than the 250's .
Brian