Page 1 of 1
Reed 453 manifold
Posted: Tue Aug 25, 2009 5:23 pm
by Dave Brillhart
Have two Reed 453 manifolds for the 820, minus the cages and carb mount. These have an opening that does not seem to fit any cage that I am familiar with, a slot about 1.0X1.75". Look like they might work well if I could find a cage. Does anyone have a complete one that could give me some direction. Thanks, Dave
Re: Reed 453 manifold
Posted: Fri Aug 28, 2009 8:24 pm
by Brian Thomas
Hi
I have a good friend that might be able to help you out .
PM me and I will pass the info along on how to contact him .
Brian
Re: Reed 453 manifold
Posted: Sat Aug 29, 2009 11:02 am
by louie figone
Dave, it sounds as though you have only the base of the manifold, the 453 is a two part manifold for the 610-820, the REED 432 Power Products dual manifold bolts to the 453 base and then you use two pyramid reed units. Reed calls the 453 a "Y" Type dual top manifold.
Louie
Re: Reed 453 manifold
Posted: Mon Aug 31, 2009 11:22 am
by Dave Brillhart
Thanks Louie, All I had were the bases, and could not figure out what the top and cage configuration was. That makes sense.