SP125 Chainsaw Conrods

[mcbob]

I have just bought up a few old SP125C engines to salvage the conrods and cranks from now since these ain't a Kart engine i wish to know would these rods be the same as the ones that carry the big end that won't needle your block and did these get offered as a kart part from McCulloch.
This rod has thrust washers either side of the top needle bearings
Wrist pin no 89204
Conrod no 88623
The SP125C doe's not have boost ports like the 101 series
The 101D and 101D uses 86415

Now were do i find a piston to suit the 101's that will take this rod assy ?

Mc Bob.

[Ronald Cubel]

Vince Hughes Has them I think

[mcbob]

Vince Hughes Has them I think

Thanks Ron

Bob.

[Jacob Jay]

Bob- these have the encapsulated big end needles? My SP blocks right now have open needles, same as the CP and kart engines. I have one 101 engine with a 9/16" wrist pin piston but the pin bearings are in the piston.

[mcbob]

Thanks Jacob ................................

Mc Bob.