Even before my time

Dominic Salvato · Post by **Dominic Salvato** » Sat Jul 03, 2010 10:09 am

This one is a 700 5 port.

Rick Chapman · Post by **Rick Chapman** » Sun Jul 04, 2010 2:51 pm

Dominic...
What McCulloch is the engine on the left side of the kart?
It has the spark plug cover that is yellow and it attaches to the spark plug.
I have one of those covers and it is just hanging on the peg board.
Want it???
Let me know...

Rick
Rixkart@aol.com

Dominic Salvato · Post by **Dominic Salvato** » Sun Jul 04, 2010 3:46 pm

It's a Mac-6 Rick, Sure I can use it. Contact me at dominics459@gmail.com

Dominic Salvato · Post by **Dominic Salvato** » Sat Jul 10, 2010 7:10 pm

Getting there.

ted johnson · Post by **ted johnson** » Sun Jul 11, 2010 8:47 am

Say, Dominic, what black finish are you using on the steering shaft, tie rods and control rods for the Caretta? I used black zinc plating on my Van Tech, but the black component wore off the pedals from my shoes in ten minutes. Any suggestions? Thanks. Ted

david a luciani · Post by **david a luciani** » Sun Jul 11, 2010 12:12 pm

i'd like to know that too.
dave

Dominic Salvato · Post by **Dominic Salvato** » Sun Jul 11, 2010 6:42 pm

The steering wheel has the original wrapped tape. There is no chrome and so few parts I just cleaned them up with an SOS pad and repeat when needed. The wheels are not the ones for it. I have the steel wheels exactly like the ones on the very first Caretta. If you notice this Caretta has leg room.

butch campbell · Post by **butch campbell** » Sat Jul 24, 2010 11:20 pm

You can add another mak kart to the ones known I have one that I raced in the early 60s had a power products AH58 on it now that I'm retired hope to restore it. I'm located in Prattsburgh N.Y.

david a luciani · Post by **david a luciani** » Sun Jul 25, 2010 12:47 pm

hi Butch,
i live on the east coast too (Ct.)
Scott is having a vintage race this week end in Avon NY.
maybe you're close enough to stop by and see the karts at least .
dave

butch campbell · Post by **butch campbell** » Sun Jul 25, 2010 9:28 pm

hi dave
darn wish I could make it but can't. I'm not to far from thier was threw thier 2 week ago its aroun 40 mile from here take care Butch

Even before my time

Re: Even before my time

Re: Even before my time

Re: Even before my time

Re: Even before my time

Re: Even before my time

Re: Even before my time

Re: Even before my time

Re: Even before my time

Re: Even before my time

Re: Even before my time