Homelite K-92 Gaskets

Jeff Troy · Post by **Jeff Troy** » Wed May 06, 2009 8:32 pm

Hi, Buds,

I'm doing a pair of Homelite 92's (KL & KR) to replace the AH-58's on my stub-axle Spitfire.

Anyone have gasket sets? They are probably the same as one of the Zip saws, but not sure about the cylinder base and intake gaskets.

Please tap here or call the cell if you have gaskets available. Looks like I need gaskets (two each) for the the cylinder base-to-case, intake-to-case, reed cage-to-intake, breaker plate-to-case, and carburetor-to-reed cage. If more than two sets are available, four would be even better!

BTW - If anyone needs graphics for the KL-92 and KR-92 tit shrouds, I'm working on them. They are slightly different from the 100's in more ways than just the numerals.

Thanks, buds, and warmest regards...

Rob Voska · Post by **Rob Voska** » Thu May 07, 2009 7:02 am

Jeff NAPA sells gasket paper......you cna cut your own out. Lots of the old gaskets shrink over time.

Homelite K-92 Gaskets

Homelite K-92 Gaskets

Re: Homelite K-92 Gaskets