GEM Quiet One Adapter: G1141 fits Power Products or West Bend 500 (2.250 cc mounting holes) G1140 fits West Bend 580/700 (2.44 cc mounting holes) Outside holes are 3.060 cc, West Bend 610/820.

Mark, my mistake, it Hanson Rivet & Supply Co. I don't know if they have a minimum order, this package has 100 rivets.

Mark, the rivets I have gotten from Air Craft Spruce are brass. I usually buy my rivets from Henderson Rivet Co. in Southern Calif.

Air Craft Spruce has a brake lining rivet tool, it works on the max torque shoes also. About $30.00 The proper size rivets are 4-4, Air Craft Spruce has them at .03 each.

Very nice Scott!

82027, 3/4 inch straight shaft pto, counterclockwise rotation @ pto, rated 7 HP @ 7000 rpm, it is considered a "utility usage engine". It came with a .094 head gasket, put a .020 head gasket in it, it will pull 10 HP @ 8000 rpm. Good motor, putting a good kart clutch will not be possible with that 3...

Michael, Dick Flourey of Medford OR had two Chilton tanks (5 qt.) at Dixon this past weekend, they both needed work (dents) but seem to be useable, they could be repaired, I believe he was asking $60.00 each.

Brian, did you measure the height of the exhaust port to the top of the cylinder and also to the bottom of the cylinder (gasket surface)? Tecumseh painted the AH 58's white for Rupp.

Scott, Thanks for the article and update on Bob, I ran against him in '67 at Riverside Nationals. Needless to say he was in front of me.

Louie

Bill, The Tecumseh Mechanics Manual calls for the open end of the wrist pin to be on the exhaust side.